Pineapple

water feature

A classic and timeless design water feature, it sits happily in an ultra-modern courtyard, or an English country garden.

This lightweight, stone-effect, water feature delivers the sights and sounds of moving water whilst encouraging birds to visit for a drink. Powered by a long lasting, quick charge battery which is safe, and easy to access means that no mains cables or plumbing are required. A solar panel upgrade allows you to ‘run and recharge’ your feature using energy from the sun.

Features
Setting up and running
Specification

Your Liberty feature can be located almost anywhere. Select somewhere that you will get maximum enjoyment from the feature both day and night.

Ensure the ground is level. Remove the parts from the pack and check them against the parts list in your instruction manual. Assemble the feature as per the instructions, or watch the ‘How to set up your Liberty feature’ video, featured here.

Select the time you want your feature to run for, using the remote control. You have a choice of 2, 3 or 4 hours, or continuously. Choosing a programmed time will run the feature from the moment you press the button until the time is up, then re-starts the feature at the same time the following day, for the same amount of time. This will continue until either the battery runs out, or you make a different running selection.

If you choose to run the feature on continuous running, the feature will run until the battery runs out, or you make a different running selection. If you install the solar panel upgrade the running times will differ as the panel charges the battery, as well as running the feature. See Solar Panel upgrade page for more information.

Follow the Running Your Feature instructions for how to charge the battery, add the solar upgrade and ongoing care of the feature.

To find your local Liberty stockist, go to the 'where to buy' page.

Charging the battery:

To charge the battery, follow the instructions that came with the feature. 
Being Lithium, the battery is quick to charge, in approximately 3 hours.

Topping up:

As the feature only holds a small volume of water the level will gradually drop due to splash and evaporation. It is important to check, and top up, your feature regularly, to prevent it drying out. If the feature dries out and the pump runs dry it will cause pump damage.

Upgrading to the Solar Panel:

Adding the Solar Panel Upgrade to your Liberty feature allows you to harness the power of the sun to run your feature. The unique ‘run and recharge’ technology, along with a Lithium battery, mean that, in good sunlight the feature should run continuously for many days without having to be charged indoors.

Follow the instructions manual for installing the Solar Panel to your feature.

Keeping the pump clean:

The pre-filter foam on the pump is there to prevent small particles getting into the impellor and blocking the running of the pump. You should check the pump foam occasionally to ensure it doesn’t block, and slow the water flow down. Clean if the flow reduces or every few weeks, otherwise. It is also advisable, while you have the pump open, to pull out, and rinse the impellor.

Keeping the feature clean:

Over time the feature may pick up every day dirt and grime. Clean the feature by wiping down with a damp cloth or sponge. If the water gets dirty, simply poor out and refresh. If you have problems with algae on your feature and prefer to treat it, use a product such as Blagdon Feature Algae Control. However, if you prefer to treat the feature with something wildlife and pet friendly, then use a product such as Blagdon extract of Barley Straw which reduces cloudy green water, cotton wool algae and filamentous algae.

Running from mains power:

Although the Liberty Features are designed as cable-free, they can still be run from mains power if you prefer.  If the low voltage, 5m charger cable does not reach your socket, you can use a Liberty mains extension cable, available as an accessory. If you run the feature from an indoor power socket you can add a timer to the plug which will give you the option to run the feature when you desire.

 

  • Freedom to instantly locate anywhere
  • Powered by revolutionary Lithium battery system
  • Able to run for up to a week without charging (2 hours a day)
  • Remote control for 2/3/4 hour programmes or continual use
  • Quick to recharge battery (within 3 hours)
  • Classical design with intricate detail to compliment your garden
  • Includes pump, battery, remote control, charger and step-by-step set up guide
  • 3 year guarantee

Technical data

  • DC 6 ~ 8.0 Volt Low Voltage
  • 1.25 Watts
  • 180 ltr/hr (48gal/hr)
  • 1.25m (4’1”) max head
  • 120cm low voltage cable for pump
  • 40cm low voltage cable for remote control receiver
  • 5m low voltage cable for battery charger
  • approved IP68

Pack dimensions

  • 56cm (H) x 58cm (W) x 46.5cm (D)

Feature dimensions

  • 86cm (H) x 48.5cm (W) x 48.5cm (D)
  • 4.5 litres (1.2 gallons)

Mains Free

Unique, quick recharge technology

Liberty water features and fountain pumps are run by a rechargeable Lithium battery and…

Solar Upgrade

Run & recharge system

The Liberty Solar Panel upgrade is designed as an additional power source for the battery-run…

Timer Functions

Pre-programmed running times

Run your Liberty Feature or pond pump with the pre-programmed running times or continually…

Varied Styles

Beautiful designs for all tastes

A variety of sizes and styles from classical to contemporary to suit any garden

Are you looking for a larger feature to keep fish or set up a pond?

Facebook
Where to buy
Subscribe to our Newsletter