Liberty Features can be located almost anywhere. Select somewhere that you will get maximum enjoyment from the feature both day and night.
Ensure the ground is level. Remove the parts from the pack and check them against the parts list in your instruction manual. Assemble the feature as per the instructions and add water.
Select the time you want your feature to run for, using the remote control or power set buttons. See How To page for further details.
If you chose to install the solar panel upgrade the running times will differ as the panel charges the battery, as well as running the feature. See Solar Panel upgrade page for more information.
See our How To videos for help setting up your feature.
Charging the battery:
To charge the battery, remove it from the feature, plug the charger cable to the battery and plug that into an indoor mains socket. The battery is Lithium so is quick to charge, in less than 5 hours. For more information see the instructions that came with the feature.
As the features only hold a small volume of water the level will gradually drop due to splash and evaporation. It is important to check, and top up, your feature regularly to prevent it drying out. If the feature dries out and the pump runs dry it will cause pump damage.
Upgrading the Solar Panel:
Adding the Solar Panel Upgrade allows you to harness the power of the sun to run your feature. The unique ‘run and recharge’ technology, along with a Lithium battery, mean that, in good sunlight the feature should run continuously for many days, or weeks, without having to be charged. See the instruction manual for installing the Solar Panel to your feature.
Keeping the pump clean:
The pre-filter foam on the pump prevents dirt getting into the pump impellor and blocking the running of the pump. You should check and clean the pump foam occasionally to ensure it doesn’t block and slow the water flow down. Clean when the flow reduces or check every few weeks. It is also advisable, while you have the pump open, to pull out and rinse the impellor. See 'How to' clean the pump in the short video here.
Keeping the feature clean:
Over time the feature may pick up every day dirt and grime. Clean the feature by wiping down with a damp cloth or sponge; do not use detergents on the feature. If the water gets dirty, simply poor out and refill with clean water. If you experience algae on your feature and prefer to treat it, use a product such as Blagdon Feature Algae Control. However, if you prefer to treat the water with something wildlife and pet friendly, then use a product such as Blagdon extract of Barley Straw which reduces cloudy green water, cotton wool, and filamentous algae. Click here for more information on our range of Feature Treatments
Running from mains power:
Although the Liberty Features are designed as cable-free, they can also be run from mains power. See diagram below. If the low voltage, 5m charger cable does not reach your socket, you can use a Liberty mains extension cable, available as an accessory. If you run the feature from an indoor power socket you can add a timer to the plug which will give you the option to run the feature when you desire. See ‘Extending the mains and solar cable’ video.
Your Liberty Flower Fairy and Bowl will come with either a Remote Control Powerset or Easy Power System, get to know both below:
For instruction manuals for either set up please visit our downloads section
Liberty Remote Control Powerset
Liberty Easy Power System